|
|
May 25, 2024
|
|
AUTO 283 - Engine Performance III (R only) CE
An advanced course focusing on emission controls and driveability. Class discusses current OBD formats in detail including interpretation of DTCs, freeze-frame data, serial data, and readiness monitors. Exhaust gas analysis is covered. Laboratory exercises emphasize current service and diagnostic procedures. May be taken with AUTO 282 . PREREQUISITE(S): A grade of C or better in AUTO 180 . Two hours lecture, three hours laboratory, one hour discussion each week.
4 semester hours
Course Outcomes: Upon completion of this course, a student will be able to:
- Verify driveability complaint.
- Locate and utilize service information to diagnose complaint (TSB’s, vehicle service history, DTC charts, repair procedures.
- Retrieve DTC’s using scanner.
- Retrieve Freeze-Frame data using scanner.
- Retrieve primary/secondary ignition patterns.
- Review Readiness Monitors using scanner.
- Interpret misfire and fuel control monitors.
- Interpret oxygen sensor/heater DTC’s and monitors.
- Interpret catalyst monitor.
- Interpret Exhaust Gas Recirculation , and Diagnostic Trouble Codes and monitors.
- Interpret Evaporative Emission Control , Diagnostic Trouble Codes and monitors.
- Interpret 5 gas analyzer results.
- Diagnose rich exhaust/poor fuel economy complaint.
- Diagnose lean exhaust/lacking power complaint.
- Diagnose hesitation/stumble complaint.
- Diagnose rough idle/stalling complaint.
- Diagnose no start complaint.
- Diagnose misfire/cut-out complaint.
- Diagnose knock/back-fire/run-on complaint.
- Diagnose incorrect turbo- or super-charger operation.
View Schedule of Classes
Add to Favorites (opens a new window)
|
|
|